In-Line Resin Heaters

Description

The Palmer In-Line Resin Heater features: higher flow rates, better control over temperature changes and an easy-maintenance design.

Optimum mixing is achieved when the chemicals and sand are at the same temperature. With the Palmer UL-Listed Resin Heater, you can safely heat your resin to any desired temperature. This will work with a re-circulating and start-stop system. A safe, efficient, accurate digital temperature read-out is available.

If you require a heater that will adjust to your operation, rather than having your operation adjust to your heater, then you need to check out the In-Line Resin Heater by Palmer.

• Low to High Flow Rates
• Precise Control of Temperature
• Easy-maintenance Design

Specs

• Wattage:3,000
• Voltage:220 volt
• Performance:See chart
• Outputs:65º - 105º F (18º - 41º C) (at 231 cubic-in./min. volume)
• Maximum Temp.:135º F (57º C)
• Cycling Accuracy:+/- 3º F (1.7º C)
• Fluid Pressure:2000 psi (137.9 bar)
• High Limit Thermostat:Adjustable BiMetal Contact
• Fluid Passage:.787” dia. x 106” lenght
  (with fluid core static mixer inserts) (1.9 cm x 269 cm)
• Inlet:1/2” npt (1.3 cm)
• Heating Area:262”2 (1690 cm2)
• Weight:70 lbs. (31.75 kg)
• Dimensions:24” H x 9” W x 6” D (61 cm H x 23 cm W x 15 cm D)
• Outlet:1/2” npt (1.3 cm)
• UL Approved
• For added safety,no contact between element and material being heated